Bearing Replacement - Suzuki RM250 Owner's Service Manual

14-4 FRONT AND REAR WHEELS
WHEEL BEARING
Inspect the inner race play of the bearings while it is in the
wheel. Rotate the inner race by finger to inspect for abnormal
noise and smooth rotation. If abnormal noise occurs or if rough
movement is noted, replace the bearing with a new one.

BEARING REPLACEMENT

• Remove the dust seals using the special tool.
 09913-50121: Oil seal remover
Removed dust seal and bearing must be replaced with
a new one.
• Remove the bearings with the special tool.
 09921-20240: Bearing remover set
• Remove the spacer.
• Apply grease to the bearings.
• Reassemble the bearings and spacer with the special tool.
• Fit the dust seals and apply grease to their lips.
 09924-84521: Bearing installer set
 99000-25010: SUZUKI SUPER GREASE "A"
NOTE:
* Install the left side (disc side) bearing first and then the right
side bearing.
* After installing the bearings, inspect the bearings for smooth
movement.
* When installing the dust seal, place the manufacturer's code
indicated side of the dust seal outside.
CAUTION
(or equivalent grease)
Left
Left
Right
Right