Suzuki RM-Z250 Owner's Service Manual page 86

5-4 ENGINE REMOVAL AND INSTALLATION
• Disconnect the magneto lead wire coupler A and clamp.
• Remove the cable bracket bolt B and disconnect the clutch
cable.
NOTE:
Mark the clutch cable at which the bracket slit set for correct
reinstallation.
• Remove the carburetor. (!12-5)
• Remove the ignition coil/plug cap. (!2-7)
• Remove the cotter pin C, washer D and clip E.
• Remove the kick starter lever F.
• Remove the brake pedal spring G, master cylinder rod pin H
and brake pedal I.
• Remove the gearshift lever J.
NOTE:
Mark the gearshift shaft head at which the gearshift lever slit set
for correct reinstallation.
• Remove the engine sprocket cover K and chain guide plate
L.