CHECKING OF CONNECTIONS
CHECKING OF CONNECTIONS
Dealing with stains, rust, moisture, etc. on the con-
nector.
1. Disconnect:
2. Dry each terminal with an air blower.
3. Connect and disconnect the connector two or
4. Pull the lead to check that it will not come off.
5. If the terminal comes off, bend up the pin 1
6. Connect:
NOTE:
The two connectors "click" together.
7. Check for continuity with a tester.
NOTE:
S If there is no continuity, clean the terminals.
S Be sure to perform the steps 1 to 7 listed above
S For a field remedy, use a contact revitalizer avail-
S Use the tester on the connector as shown.
1-4
S Connector
three times.
and reinsert the terminal into the connector.
S Connector
when checking the wireharness.
able on the market.
GEN
INFO