Removal; Inspection - Yamaha TDM850 1996 Service Manual

A.C. MAGNETO AND STARTER WHEEL GEAR

REMOVAL

1. Remove:
S Bolt (rotor) 1
S Washer 2
NOTE:
S Loosen the bolt (rotor) 1 while holding the mag-
neto with the sheave holder 3 .
S Do not allow the sheave holder 3 to touch the
projection on the rotor.
Sheave holder:
90890-01701
2. Remove:
S A.C. magneto 1
NOTE:
S Remove the rotor 1 using the rotor puller 2 and
crankshaft protector 3 .
S Fully tighten the tool holding bolts, but make sure
the tool body is parallel with the magneto. If nec-
essary, one screw may be backed out slightly to
level tool body.
Flywheel puller:
90890-01362
Crankshaft protector:
90890-01382

INSPECTION

1. Check:
S Starter clutch operation
Clutch operation checking steps:
S Install the starter wheel gear to the starter clutch,
and hold the starter clutch.
S When turning the starter wheel gear clockwise
A , the starter clutch and the wheel gear should
be engaged.
If not, the starter clutch is faulty. Replace it.
S When turning the starter wheel gear counter-
clockwise B , the starter wheel gear should turn
freely.
If not, the starter clutch is faulty. Replace it.
4-39
ENG