Checking The Connections - Yamaha YBR250 2007 Service Manual

CHECKING THE CONNECTIONS

CHECKING THE CONNECTIONS
Check the leads, couplers, and connectors for
stains, rust, moisture, etc.
1. Disconnect:
2. Check
3. Check:
NOTE:
If the pin 1 on the terminal is flattened, bend it up.
4. Connect:
NOTE:
Make sure that all connections are tight.
NOTE:
•
•
•
1-6
• lead
• coupler
• connector
• lead
• coupler
• connector
Moisture Dry with an air blower.
-->
Rust/stains Connect and disconnect
-->
several times.
• all connections
Loosen connection
• lead
• coupler
• connector
5. Check
• continuity
(with the pocket tester)
Pocket tester
90890-03174
If there is no continuity, clean the terminals.
When checking the wire harness, perform
steps (1) to (3).
As a quick remedy, use a contact revitalizer
available at most part stores.
GEN
INFO
Connect properly
-->