Funkwerk bintec R1200 User Manual page 56

5
Submenu IP
54 bintec User's Guide
RIP S and RIP R
END ECEIVE
Description
none (default value)
RIP V2 multicast
RIP V1 triggered
RIP V2 triggered
RIP V1
RIP V2
RIP V1 + V2
Table 5-9: Selection options for RIP S
P A offers the following selection options:
ROXY RP
Description
off (default value)
on (up or dormant)
contain the following selection options:
Meaning
Not activated.
Only for RIP S
END
The gateway waits for version 2 RIP packets
with RIP V2 multicast address 224.0.0.9.
RIP V1 messages are sent rsp. received and
processed as per RFC 2091
➤➤
(Triggered RIP).
RIP V2 messages are sent rsp. received and
processed as per RFC 2091
➤➤
(Triggered RIP).
For sending and receiving version 1 RIP pack-
ets.
For sending and receiving version 2 RIP pack-
ets.
For sending and receiving RIP packets of both
version 1 and 2.
and RIP R
END ECEIVE
Meaning
Deactivates Proxy ARP for this WAN partner.
The gateway answers an ARP request only if
the status of the connection to the WAN partner
is up (active) or dormant (idle). In the case of
dormant, the gateway only answers the ARP
request; the connection is not set up until
someone actually wants to use the route.
WAN Partner