Funkwerk bintec R1200 User Manual page 19

WAN Partner
Static
In static channel bundling, you specify right from the start how many B-channels
the gateway uses for connections to the WAN partner, regardless of the amount
of data transferred.
The A S menu consists of the following fields:
DVANCED ETTINGS
Field
Callback
Static Short Hold (sec)
Idle for Dynamic Short
Hold (%)
Delay after Connection
Failure (sec)
Layer 1 Protocol
Submenu Advanced Settings
Description
Activates the callback function. Possible val-
ues: see table "Callback selection options," on
page 20.
Idle time in seconds for static short hold.
Default value is 20.
e.g.
10 for FTP connections
20 for LAN to LAN connections
90 for Internet connections
Idle time in percent of the interval of charge for
dynamic short hold.
Only activate if charging pulses are transmitted
during the connection (AOCD).
Block timer. Indicates the wait time in seconds
before the gateway tries again after an attempt
to establish a connection has failed.
Defines which Layer 1 Protocol the gateway is
to use. This setting applies to outgoing connec-
tions with the WAN partner and to incoming
calls from the WAN partner, only if they have
been identified from the calling party number.
Possible values: see table "Selection options of
Layer 1 Protocol," on page 23.
You only need to make changes here if explic-
itly required.
3
bintec User's Guide 17