Table of Contents
Advertisement
8.
Only perform those steps given in each procedure.
9.
After replacing an FRU, confirm that the system is operating normally.
10.
There are many pins on the PCBs and sharp edges on both the PCBs and shielding.
Be careful when working with these components.
11.
The numerous screws securing the system are not interchangeable. When reassembling
the system, follow the appropriate procedures and figures because the various screw
dimensions are given.
12.
If the part description is different between the Maintenance Manual and the Parts
Catalog, the Parts Catalog description will be listed in parenthesis for the first
reference.
Tools needed for FRU replacement:
1.
Phillips head screwdriver
2.
Tweezers
4-5
Advertisement
Chapters
Table of Contents
