Toshiba Tl000LE User Manual page 62

3.11 HARD DISK TEST
CAUTION: The contents of the hard disk will be erased when subtest 02,03,04,06,
or 08 is run. Before running the test, transfer the contents of the hard
disk to thefloppy disk. This can be done with the MS-DOS BACK-
UP command. After the test, enter the MS-DOS FDISK command,
which will set the partition. Then enter the MS-DOS FORMAT com-
mand. (See the MS-DOS manualfor details.)
OPERATIONS
1.
When you select the hard disk test on the DIAGNOSTICS TEST MENU, the
following message will appear:
*TEST CONTROL MENU*
TEST DRIVE MENU
1 - UNIT 1
2 - UNIT 2
9 -
Exit to DIAGNOSTICS MENU
PRESS [1]-[2] or [9] KEY ?
2. Select the drive number of the hard disk to be tested and press Enter. The following
message will appear:
HOC F/W error retry (l:yes,2:no)
?
3. This message is used for selecting to retry the operation when the hard disk controller
detects an error. Select 1 or 2 and press Enter. The following message will appear:
Data compare error dump (l:no,2:yes) ?
4. This message is used for selecting to do a dump operation when a data compare error
is detected. Select 1 or 2 and press Enter. The following message will appear:
Detail status display (l:no,2:yes) ?
3-28