Toshiba Tl000LE User Manual page 81

3. Bad track FORMAT
Executes the formatting of a specified cylinder and track as a bad track.
4. Bad track CHECK
Checks for bad tracks by performing a read operation for all tracks on the hard disk;
a list of bad tracks is then displayed.
3.20.2 Operations
CAUTION: After physicalformatting is finished, enter the MS-DOS FDISK com-
mand, which will set the partition. Then enter the MS-DOS
FORMAT command. (See the MS-DOS manual for details.)
1. After loading the MS-DOS, insert the Diagnostics Disk in the floppy disk drive. Type
in A:HDF AT, then press
Enter.
The following display will appear:
DIAGNOSTICS - HARD DISK FORMAT : Vx.xx
1 - All track FORMAT
2 - Good track FORMAT
3 - Bad track FORMAT
4 - Bad track CHECK
9 - Exit to DIAGNOSTICS MENU
Press [NUMBER] key
?
2. All track FORMAT selection
(1)
When all track FORMA T
(1)
is selected, the following message will appear:
Drive number select (1:#1,2:#2)
?
(2) Select a drive number. Type the drive number and press
Enter.
The
following message will appear:
Interleave number (1/1-8) ?
3-47