Toshiba Tl000LE User Manual page 55

3. Select the media type of the floppy disk to be tested, then press
Enter.
The following
message will appear.
FDD-TEST V x.xx SOB-NO ..
??
PASS .. 0000 ERRCNT .. 000
CMD ••
xx
STATUS xxx ADR xxxxx
WD
xx
RD
xx
01 - Sequential read
02 - Sequential read/write
03 - Random address/data read/write
04 - Write specified address
05 - Read specified address
99 - Exit to DIAGNOSTICS MENU
4. Select the subtest number, then press
Enter.
The following message will appear.
TEST LOOP (1:Yes/2:No) 1
If you select Yes (by typing in 1 and pressing
Enter):
Each time a test cycle ends,
it increments the pass counter by one and repeats the test cycle.
If you select No (by typing in 2 and pressing
Enter):
At the end of a test cycle, the
test execution is tenninated and you exit to the subtest menu.
5. Type in 1 or 2, then press
Enter.
The following message will appear:
ERROR STOP (1:Yes/2:No) 1
If you select Yes (by typing in 1 and pressing
Enter):
When an error occurs, the error
status is displayed. Execution of the test program stops and the operation guide is
displayed on the right side of the display screen.
If you select No (by typing in 2 and pressing
Enter):
When an error occurs, the error
status is displayed. The error counter increases by one and you go to the next subtest.
6. Type in lor 2, then press
Enter.
The following message will appear.
Max. Track
Max. Head
Max. Sector
=
79
=
1
= xx
Test Start Track
??
3-21