Toshiba Tl000LE User Manual page 20

Check 3
2-14
The IRT program tests the system board. If an error occurs in the IRT
program, the error message appears on the screen and beep sounds are
generated. If the following error messages do not appear and the beep sounds
are not heard, perform PROCEDURE 3. (The boldface messages shown
below are visible on the screen. The normal messages do not appear on the
screen and only beep sounds are generated.)
V-RAM TEST ERROR BEEP (1 LONG and 2 SHORT)
KEYBOARD ERROR
RESUME ERROR BEEP (1 SHORT)
If an error for storing data occurs in the resume mode, the following message
will appear.
WARNING RESUME FAILURE
PRESS ANY KEY TO CONTINUE
XXXX MEMORY ERROR
DISK CONTROLLER FAILURE
DISK 0 FAILURE
FDD ERROR
HARD RAM TEST BEEP (1 SHORT)
If an error occurs during the read test, the following message will appear.
WARNING: DATA IN HARD RAM WAS LOST
YOU MUST FORMAT HARD RAM BEFORE USE
PRESS ANY KEY TO CONTINUE