Toshiba Tl000LE User Manual page 42

3-8
5. After typing in a test number (l through 11) from the DIAGNOSTIC TEST MENU,
press
Enter.
A test-specific display will appear. For example, the following screen
shows the system test, which appears when you type
1
and press
Enter.
ROM-TEST V x.xx SUB-NO ..
??
PASS ..
OOOO
ERRCNT ..
OOO
CMD .. xx
STATUS xxx ADR xxxxx WD xx RD xx
01 - BIOS ROM CHECKSUM
99 -
EXIT TO DIAGNOSTICS MENU
6. Select a subtest. See Table 3-1 for a list of the valid subtests. Type in the subtest
number, then press
Enter.
The following message will appear:
TEST LOOP (1:Yes/2:No) 1
If you select Yes (by typing in
1
and then pressing
Enter):
Each time a test cycle ends,
it increments the pass counter by one and repeats the test cycle.
If you select No (by typing in 2 and pressing
Enter):
At the end of a test cycle, the
test execution is terminated and you exit to the subtest menu.
7. Type in
1
or 2, then press
Enter.
The following message will appear:
ERROR STOP (1:Yes/2:No) 1
If you select Yes (by typing in 1 and pressing
Enter):
When an error occurs, the error
status is displayed. Execution of the test program stops and the operation guide is
displayed on the right side of the display screen.
If you select No (by typing in 2 and pressing
Enter):
When an error occurs, the error
status is displayed. The error counter increases by one and you go to the next pass
of the subtest.
8. Type in 1 or 2, then press
Enter
and the test program will run. Each subtest is
described in Table 3-1 of Section 3.3.