Toshiba Tl000LE User Manual page 26

PROCEDURE 3
Connector Check
The FDD is connected to the system unit by the FDD cable. This cable may be disconnected
from the system unit. Disassemble the system unit and check the FDD cable. Disassembly
procedures are described in Part 4.
Check 1
Check 2
Check 3
2-20
Check that the following cable is correctly connected to the system board.
FDD 1 cable
------->
System board PJ5
If this cable is disconnected, connect it to the system unit and perfonn
PROCEDURE 1 and 2. If the problem still exists, perfonn Check 2.
The FDD may be defective. Replace it with a new FDD, then perfonn
PROCEDURE 1 and 2. If the problem still exists, perfonn Check 3.
The system board may be defective. Replace it with a new system board.