Toshiba Tl000LE User Manual page 63

5. This message is used for selecting to display the detail status on the screen or not. The
detail status is described in Section 3.15. Select
1
or 2 and press
Enter.
The following
message will appear:
HOD-TEST V x.xx SUB-NO ..
??
PASS .. 0000 ERRCNT .. 000
CMD ••
xx
STATUS xxx ADR xxxxx WD xx RD xx
01 - Sequential read
02 - Address uniqueness
03 - Random address/data
04 - Cross talk
&
peak shift
05 - Write/read/compare(CE)
06 - Write specified address
07 - Read specified address
08 - ECC circuit
99 - Exit to DIAGNOSTIC TEST MENU
6. Select the subtest number, then press
Enter.
The following message will appear.
TEST LOOP (1:Yes/2:No) 1
If you select Yes (by typing in
1
and then pressing
Enter):
Each time a test cycle ends,
it increments the pass counter by one and repeats the test cycle.
If you select No (by typing in 2 and then pressing
Enter):
At the end of a test cycle,
the test execution is terminated and you exit to the subtest menu.
7. Type in
1
or 2, then press
Enter.
The following message will appear:
ERROR STOP (1:Yes/2:No) 1
If you select Yes (by typing in
1
and pressing
Enter):
When an error occurs, the error
status is displayed. Execution of the test program stops and the operation guide is
displayed on the right side of the display screen.
If you select No (by typing in 2 and pressing
Enter):
When an error occurs, the error
status is displayed. The error counter increases by one and you go to the next subtest.
3-29