Toshiba Tl000LE User Manual page 19

PROCEDUREl
Message and Beep Sound Check
After the power is turned on, the system performs the initial reliability test (IRT) which is a
program stored in BIOS ROM on the system board. The IRT tests and initializes each IC on
the system board.
If an error message appears on the screen, perform Check 1, and if nothing is displayed on
the screen, perform PROCEDURE 2.
Check 1
Check 2
If the following error message appears on the screen, press any key. This
program confirms the current system configuration and the configuration
stored to RTC memory. If they are different, the following message will
appear. You can easily set the current configuration in the RTC memory by
pressing any key. If another error message appears, perform Check 2.
***SYSTEM CONFIGURATION ERROR***
A checksum error occurred in the configuration RAM.
Press any key for default set ....
If the following message appears, press any key. At this time the resumed data
will be erased. If another error message appears, perform Check 3.
WARNING: RESUME FAILURE.
PRESS ANY KEY TO CONTINUE.
2-13