Assembling And Installing The Rear Brake Master Cylinder - Yamaha FZS600'98 Service Manual

FRONT AND REAR BRAKES
CAUTION:
Brake
surfaces and plastic parts. Therefore,
always clean up any spilt brake fluid
immediately.
3. Bleed:
S brake system
Refer to "BLEEDING THE HYDRAULIC
BRAKE SYSTEM" in chapter 3.
4. Check:
S brake fluid level
Below the minimum level mark a ! Add
the recommended brake fluid to the proper
level.
Refer to "CHECKING THE BRAKE FLUID
LEVEL" in chapter 3.
5. Check:
S brake lever operation
Soft or spongy feeling ! Bleed the brake
system.
Refer to "BLEEDING THE HYDRAULIC
BRAKE SYSTEM" in chapter 3.
EB702292
ASSEMBLING AND INSTALLING THE REAR
BRAKE MASTER CYLINDER
1. Install:
S copper washers (New) 1
S brake hose 2
S union bolt 3
CAUTION:
When installing the brake hose onto the
brake master cylinder, make sure that the
brake pipe touches the projection a on
the brake master cylinder.
Proper brake hose routing is essential to
insure safe motorcycle operation. Refer
to "CABLE ROUTING".
2. Fill:
S brake fluid reservoir
(to the maximum level mark a )
7-27
CHAS
fluid may damage
30 Nm (3.0 mSkg)
Recommended brake fluid
DOT 4
painted