Removing The Handlebar; Checking The Handlebar - Yamaha FZS600'98 Service Manual

1
1
HANDLEBAR
EB704100

REMOVING THE HANDLEBAR

1. Stand the motorcycle on a level surface.
Securely support the motorcycle so that
there is no danger of it falling over.
2. Remove:
S throttle cable housing 1
S throttle grip 2
NOTE:
While removing the throttle cable housing,
pull back the rubber cover 3 .
3. Remove:
S left handlebar grip 1
NOTE:
Blow compressed air between the handle-
bar and the handlebar grip, and gradually
push the grip off the handlebar.
EB704400

CHECKING THE HANDLEBAR

1. Stand the motorcycle on a level surface.
Securely support the motorcycle so that
there is no danger of it falling over.
2. Check:
S handlebar 1
Bends/cracks/damage ! Replace.
Do not attempt to straighten a bent han-
dlebar as this may dangerously weaken
it.
3. Install:
S handlebar grip
a. Apply a light coat of rubber adhesive onto
the left end of the handlebar.
b. Slide the handlebar grip over the left end
of the handlebar.
c. Wipe off any excess rubber adhesive with
a clean rag.
Do not touch the handlebar grip until the
rubber adhesive has fully dried.
7-50
CHAS