Yamaha FZS600'98 Service Manual page 215

3
2
CARBURETORS
b. Disconnect the throttle position sensor
coupler.
c. Reconnect the throttle position sensor
coupler.
NOTE:
After reconnecting the throttle position sen-
sor coupler, the tachometer switches to the
throttle position sensor adjustment mode.
d. Loosen the throttle position sensor
screws 1 .
e. Adjust the throttle position sensor angle
according to the following table:
NOTE:
The angle of the throttle position sensor is in-
dicated by the RPM which is displayed on
the tachometer.
Tachometer
Reading
1
5000 rpm
0 rpm 2
10000 rpm
3
f. After adjusting the throttle position sensor
angle, tighten the throttle position sensor
screws.
NOTE:
To exit the throttle position sensor adjust-
ment mode, start the engine or turn the main
switch to "OFF".
6-11
CARB
Throttle Adjust-
position ment
sensor angle direction
Correct ——
a
Incorrect
Incorrect
b