3
1
EB405100
REMOVING THE CLUTCH
2
1. Straighten the lock washer tab.
2. Loosen:
S clutch boss nut 1
NOTE:
While holding the clutch boss 2 with the uni-
versal clutch holder 3 , loosen the clutch
boss nut.
3. Remove:
S spacer 1
S bearing 2
NOTE:
Insert two M6-mm bolts 3 into the spacer
and then remove the spacer by pulling on the
bolts.
EB405400
CHECKING THE FRICTION PLATES
The following procedure applies to all of the fric-
tion plates.
1. Check:
S friction plate
Damage/wear ! Replace the friction
plates as a set.
2. Measure:
S friction plate thickness
Out of specification ! Replace the friction
plates as a set.
NOTE:
Measure the friction plate at four places.
EB405410
CHECKING THE CLUTCH PLATES
The following procedure applies to all of the
clutch plates.
1. Check:
S clutch plate
Damage ! Replace the clutch plates as a
set.
2. Measure:
S clutch plate warpage
(with a surface plate and thickness gauge
1 )
Out of specification ! Replace the clutch
plates as a set.
4-34
ENG
CLUTCH
Universal clutch holder 3
90890-04086
Friction plate thickness
2.94 X 3.06 mm
<Limit>: 2.8 mm
Clutch plate warpage limit
Less than 0.1 mm