Yamaha FZS600'98 Service Manual page 35

Part to be tightened
Side cover and frame
Garb bar
Front wheel axle
Front wheel axle pinch bolt
Front brake caliper
Front brake disc
Front brake caliper bleed screw
Compression bar
Rear wheel sprocket
Drive chain puller nut
Rear brake caliper and caliper bracket
Rear wheel axle nut
Rear brake hose union bolt
Rear brake caliper bleed screw
Rear brake disc
Sidestand
Bracket footrest and frame
Rear master cylinder and bracket
Footrest bracket and footrest
Footrest bracket (rear) and frame
Center stand nut
Footrest bracket and exhaust pipe
Footrest bracket (rear) and muffler
NOTE:
1. First, tighten the ring nut (lower) approximately 52 Nm (5.2 mSkg) by using the torque wrench, then
loosen the right nut completely.
2. Second, tighten the ring nut (lower) approximately 18 Nm (1.8 mSkg) by using the torque wrench,
then finger tighten the ring nut (center). Align the slots both ring nut and install the lock washer.
3. Final, hold the ring nuts (lower and center) and tighten the ring nut (upper) 110 Nm (11.0 mSkg) by
using the torque wrench.
MAINTENANCE SPECIFICATIONS
g
2-13
Tightening
torque
Thread size
Nm
M6 1.0 4
M8 1.25 19
M16 1.5 67
M8 1.0 20
M8 1.25 40
M8 1.25 23
M7 1.0 6
M8 1.25 23
M10 1.25 60
M8 1.25 16
M10 1.25 40
M18 1.5 117
M10 1.25 30
M7 1.0 6
M8 1.25 23
M8 1.25 23
M8 1.25 28
M8 1.25 23
M10 1.25 55
M8 1.25 28
M10 1.25 56
M8 1.25 20
M10 1.25 30
SPEC
Remarks
mSkg
0.4
1.9
6.7
2.0
4.0
2.3
0.6
2.3
6.0
1.6
4.0
11.7
3.0
0.6
2.3
2.3
2.8
2.3
5.5
2.8
5.6
2.0
3.0