Adjusting The Throttle Cable Free Play - Yamaha FZS600'98 Service Manual

ADJUSTING THE THROTTLE CABLE FREE PLAY

a
b
a
b
EB303032
ADJUSTING THE THROTTLE CABLE FREE
PLAY
NOTE:
Prior to adjusting the throttle cable free play,
the engine idling speed and carburetor syn-
chronization should be adjusted properly.
1. Check:
S throttle cable free play a
Out of specification ! Adjust.
Throttle cable free play (at the
flange of the throttle grip)
3 X 5 mm
2. Remove:
S bracket
S ignition coil
S fuel pump
3. Adjust:
S throttle cable free play
Carburetor side
NOTE:
When the motorcycle is accelerating,
throttle cable #1 1 is pulled and throttle
cable #2 2 is pushed.
a. Loosen the locknut 3 on throttle cable
#2.
b. Turn the adjuster 4 a or b to take up
any slack on throttle cable #2.
c. Loosen the locknut 5 on throttle cable
#1.
d. Turn the adjuster 6 a or b until the spe-
cified free play is obtained.
a
Direction
Direction b
e. Tighten the locknuts.
NOTE:
If the specified throttle cable free play cannot
be obtained on the carburetor side of the
cable, use the adjusting nut on the handle-
bar side.
Handlebar side
a. Loosen the locknut 1 .
b. Turn the adjusting nut 2 in direction a or
b until the specified throttle cable free
play is obtained.
Direction a
Direction b
c. Tighten the locknut.
3-14
CHK
ADJ
! Throttle cable free play
is increased.
! Throttle cable free play
is decreased.
! Throttle cable free play
is increased.
! Throttle cable free play
is decreased.