Table of Contents
Advertisement
92
/126
Passwords and
camera settings will
not be changed
Make sure you store
the default network
configuration to the
permanent flash memory
Users and passwords
will
not
be reset!
D14D Camera Manual: Operating The Camera
3.2.5
Starting the Camera With The Factory IP Address
Under certain circumstances, you may have to reset the camera to its factory IP address.
This could be the case, for example, if the IP address has been lost or the camera does
not respond to the last known IP address.
1.
Disconnect the power supply of the camera by unplugging the corresponding cable;
then reconnect the power supply of the camera.
2.
After approx. 10 seconds, the LEDs are activated and blink for about 4 seconds.
Once the blinking has stopped and all LeDs are lit permanently, hold the magnetic
3.
side of the custom tool onto the spot above the microphone labeled L in the
figure (the switch is inside the camera housing).
4.
In case you miss this step (step 3), disconnect the power supply of the camera
and start all over again.
release the custom tool when the camera
5.
emits a single sound ("boing"), which is after
approx. 40 seconds.
If you use the camera's L key to load the factory network configuration, this configuration
is not automatically saved in the camera's flash memory. When the camera is next
rebooted without using the L key, the last stored network configuration will be used.
To permanently store the new network configuration in the camera's flash memory,
open Admin Menu > Store.
As opposed to resetting the camera using Admin Menu > Reset configuration to
factory defaults, the user information will not be reset if the camera is booted using
the factory IP address.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
Notes
www.mobotix.com • sales@mobotix.com
1
4
2
3
L
Advertisement
Table of Contents
