Replacing The Microsd Card - Mobotix D14D User Manual

58
/126
Use the supplied
custom tool
Push-push:
Push the MicroSD card
in, then pull it out
D14D Camera Manual: Mounting
2.3.6

replacing The MicroSD Card

If the supplied 4-GB MicroSD card is to be replaced (for example, with a 64-GB MicroSD
card), it is best to do so before the camera is installed. The cards should only be replaced
when the camera is disconnected from the power supply.
remove the outer shell
1.
the supplied custom tool. Insert the tip of the custom
tool into the three small holes of the shell, one by one.
Lift the outer shell to loosen it from the fixtures.
Remove cable cover
2.
screws from the cable cover using the 3-mm Allen
wrench.
Remove cable cover
3.
hand, press a suitable tool (screwdriver) into the
notches provided for this purpose (red arrows).
Carefully lift the cover upwards in the direction of
the dome.
4. remove the MicroSD card: Carefully press the
MicroSD card into the mount until you hear a click.
The card now protrudes from its seat and can be
removed (tweezers may be used to facilitate
removal).
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
: Remove the outer shell using
: Remove the two M4x25 Allen
: If you are unable to do so by
www.mobotix.com • sales@mobotix.com