Table of Contents
Advertisement
First Installation Steps
5.
Insert the MicroSD card
shown (electrical contacts pointing toward the dome)
into the card slot using a tweezers. Make sure that
you hear a click when the card is inserted. The card
is now locked and can be used. If a new MicroSD
card is used, it must be formatted before use (see
Chapter 3).
6. Install cable cover: Push the cable cover back into
its seat and fasten the two M4x25 Allen screws.
When mounting the cable cover, take care to properly
align the cover with the seal of the camera housing
and the two cable guides. This is the only way to
ensure that the connections are reliably protected
against any kind of weather.
Attach the outer shell
7.
the round hole of the shell is positioned over the PIR
sensor of the camera. Gently press the shell into the
shell's seats in the camera housing. Old outer shells
(D10D, D12D) may no longer be used!
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
: Push the MicroSD card as
: Hold the outer shell so that
59
/126
Max. tightening
torque of the Allen
screws: 1 to 1.2 Nm
Advertisement
Table of Contents
