Table of Contents
Advertisement
First Installation Steps
1.
remove the outer shell
the supplied custom tool. Insert the tip of the custom
tool into the three small holes of the shell, one by one.
Lift the outer shell to loosen it from the fixtures.
remove the dome
2.
supplied plastic foil or a cotton cloth and remove it
by turning it counterclockwise.
3. Insert the lens units and mount the central lens
screw: Remove the center lock screw and the washer.
Insert the lens units into the seatings. Insert the lock
screw with a washer into the center of the camera
and gently tighten it to hold the lens units in place.
Touch the mount of the lens units only. Always avoid direct contact with the switches
on the green circuit board (ESD) in order to prevent damage arising now or later and
to avoid reducing the service life.
remove the lens cover on the image sensors:
4.
the two bars on the side of each lens cover (red
arrow) and remove the covers one after another in
the direction of the gray arrow.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
: Remove the outer shell using
: Pick up the dome using the
Note
Press
51
/126
Use the supplied
custom tool
Max. tightening
torque of the lock
screw: 1 to 1.2 Nm
Advertisement
Table of Contents
