Table of Contents
Advertisement
52
/126
RGB
SW
D14D Camera Manual: Mounting
5.
C
onnect the sensor cable to the lens mount:
Connect the R and L sensor cables with the image
sensors in accordance with the table. Example: In
the case of a D14D-DNight (color/black and white),
the R sensor cable must always be connected to the
lens mount marked with RGB, while the L sensor
cable must always be connected to the lens mount
marked SW.
Never pull the sensor cable forcefully! To remove it, first disconnect the plug by
pressing lightly on the notch (1) and then carefully pull it
upwards (2).
Always avoid direct contact with the switches on the green
circuit board (ESD) in order to prevent damage arising now
or later and to avoid reducing the service life.
Insert the sensor cable:
6.
through the space in the circuit board. Make sure that
the individual wires are gently curved and are not
bent near the plug.
Place the lens cover on the image sensors:
7.
push the lens covers one after another in the direction
of the gray arrow onto the plug until they click into
place.
Align the image sensors and cable guide:
8.
the image sensors so that the plugs of the sensor
cable point towards the interior of the dome (see
red marking in the figure). This will ensure the
images appear in the correct position later on and
not upside down. Make sure that the sensor cable
is as straight as possible and fix the cable in place
using the corresponding guides.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
Note
Insert the sensor cable
Carefully
Align
www.mobotix.com • sales@mobotix.com
1
2
Advertisement
Table of Contents
