Table of Contents
Advertisement
Network And Power Connection
The MOBOTIX factory default is Poe class 2. This default is usually fine and nothing needs
to be changed. However, the PoE power class must be changed in the browser if the
higher power class 3 is required for your application:
Admin Menu > Network Setup > ethernet interface
1.
Select
(for experts).
2.
Under Power Supply, click on
Power Wizard will appear to guide you through the PoE
3.
A
configuration steps.
4.
The camera will then need to be restarted via a hard reboot:
Disconnect the camera from the power supply. Then reconnect
it, for example, by disconnecting and then
reconnecting the Ethernet cable at the PoE
switch.
2.7.3
Power Supply Using A Switch
1.
Connect the factory pre-installed cable of the
camera to the Camera connector of the PoE
adapter.
LAN/Power connector of the PoE
2.
Connect the
adapter to the Ethernet connector of the switch/router or the Ethernet socket.
3.
Plug the RJ45 connector of the power supply unit into the
the PoE adapter.
Switch/router
LAN/www
(10.8.0.11/255.0.0.0)
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
Change.
PoE Adapter
(MX-NPA-PoE)
Camera
RJ45
PC
PC/Power connector of
Power supply
Camera
(10.8.0.99)
73
/126
Variable PoE: multiple
cameras can be operated
simultaneously from
the same switch
The IP addresses in
the diagram are shown
only as an example
For the D14D, you
should use the new blue
MX-NPA-PoE-Set –
previous MOBOTIX
network power
accessories such as the
NPA Set, Power Box,
and Power Rack
(MX-NPA-Set,
MX-NPR-4 and
MX-NPR8/20) are
not suitable for use
with the D14D
Advertisement
Table of Contents
