Cli Commands List (Rescue Mode) - D-Link DFL-900 User Manual

DFL-900/1500 User Manual
The Full tftp commands are described in the following Table A-3.
Prefix 2th
command command command
upgrade
ip tftp
backup
In the Postfix command, the meanings of keywords are listed here.
WORD: tftp server IP address
FILENAME: Upgrade configuration file image name
(preserve): string "preserve", this is optional
A.3

CLI commands list (Rescue Mode)

If the original firmware was damaged by some accidents, you may need to recover it with the factory reset process in the rescue
mode. Boot the DFL-1500 and press <tab> or <space> during the 2-second countdown process. You may refer Section 29.5.3 for
details.
Non-privileged mode
Main Sub
commands commands
?
enable (en)
exit (ex)
ip
ping
sys
status (st)
version (ver)
Note: If you don't know what parameter is followed by the commands, just type "?" following the command. Ex "ip ?". It will show
all the valid suffix parameters from "ip".
3th
Postfix command
config FILENAME WORD
FILENAME WORD
image
(preserve)
config WORD
image WORD
Table A-3 ip tftp commands description
Example
?
enable
exit
ip ping 202.11.22.33
sys status
sys version
Table A-4 Non-privileged mode of rescue mode
A.3CLI commands list (Rescue Mode)
Example
ip tftp upgrade config
conf-0101 192.168.1.170
ip tftp upgrade image
<FILENAME> 192.168.1.170
preserve
ip tftp backup config
192.168.1.170
ip tftp backup image
192.168.1.170
Show the help menu
Turn on privileged mode command
Exit command shell
Configure IP related settings
Send ICMP messages
Configure system parameters
Show the mode name and firmware version.
Show the firmware version
239
Command description
Upgrade configuration file
image from tftp server.
Upgrade system image from
tftp server.
Backup configuration file
image to tftp server.
Backup system image to tftp
server.
Command description