D-Link DFL-900 User Manual page 45

DFL-900/1500 User Manual
OSPF Area ID
Step 2. Setup LAN port
Here we are going to configure the LAN1 settings.
Setup IP Address and IP Subnet Mask, and
determine if you would like to enable the DHCP
Server. And then select Routing Protocol. Click
Apply to finish this setting.
Note, when changing
configuration may be disconnected. You may
need to reconfigure the Firewall, such as Firewall
objects, IP/MAC Binding, Authentication Exempt
Host, Virtual Server rules, IPSec/L2TP/PPTP
VPN rules, and Remote Mgmt settings.
FIELD
IP Address
IP Subnet Mask
Enable DHCP Server
IP Pool Starting Address
Pool Size(max size: 253)
Primary DNS Server
Secondary DNS Server
Lease time(sec)
Routing Protocol
OSPF Area ID
Specify OSPF area ID number
Table 3-2 Configure DMZ network settings
BASIC SETUP > LAN Settings > LAN1 Status
the LAN IP, your
DESCRIPTION
LAN1 port IP address
LAN1 port IP subnet mask
Enable LAN1 port of the DHCP Sever or not
Specify the starting address of the DHCP IP address.
Specify the numbers of the DHCP IP address.
Specify the Primary DNS Server IP address of the DHCP
information.
Specify the Secondary DNS Server IP address of the DHCP
information.
Specify DHCP information lease time
Determine to enable the dynamic routing protocol (RIP), to
receive RIP message, to send out RIP message if the
message is received or not.
Specify OSPF area ID number
Table 3-3 Configure LAN network settings
37
Basic Setup
IPv4 format or
digit string (Max
9 bits)
Range / Format EXAMPLE
IPv4 format 192.168.40.254
netmask format 255.255.255.0
Enable/Disable
IPv4 format in the
LAN1 address 192.168.40.100
range
1 ~253
IPv4 format 192.168.40.254
IPv4 format
greater than 0
None / RIPv1In /
RIPv1In+out /
RIPv2In /
RIPv2In+out /
OSPF
IPv4 format or
digit string (Max
9 bits)
Chapter 3
N/A
Enabled
20
0.0.0.0
7200
None
N/A