Table of Contents
Advertisement
Command Line Interface (CLI)
You can configure the DFL-1500 through the web interface (http/https) for the most time. Besides you can use another method,
console/ssh/telnet method to configure the DFL-1500 in the emergency. This is known as the Command Line Interface (CLI). By the
way of CLI commands, you can effectively set the IP addresses, restore factory reset, reboot/shutdown system etc. Here we will give
you a complete list to configure the DFL-1500 using the CLI commands.
A.1
Enable the port of DFL-1500
If you prefer to use CLI commands, you can use it through console/ssh/telnet methods. For using ssh/telnet feature, you must
enable the remote management first. Enable the specified port, so that you can login from the configured port.
Step 1 ¡ Ð
Enable remote management /
TELNET
Check the selected port located in the telnet
function. And customize the server port
which is listened by telnet service.
Step 2 ¡ Ð
Enable remote management /
SSH
Check the selected port located in the ssh
function. And customize the server port which is
listened by ssh service.
A.2
CLI commands list
Subsequently, we can use the console/ssh/telnet to connect the DFL-1500. After logining the system successfully, we can use
the CLI commands to configure DFL-1500. The complete CLI commands are described as follows.
Non-privileged mode
Main
Sub
commands
commands
?
enable (en)
exit (ex)
ip
ping
traceroute
Command Line Interface (CLI)
SYSTEM Tools > Remote Mgt. > TELNET
SYSTEM Tools > Remote Mgt. > TELNET
Example
?
enable
exit
ip ping 202.11.22.33
ip traceroute 202.11.22.33
Show the help menu
Turn on privileged mode command
Exit command shell
Configure IP related settings
Send ICMP messages
Trace route to destination address or hostname
123
DFL-1500 User Manual
Appendix A
Command description
Advertisement
Table of Contents
