Wan1-To-Dmz1 Connectivity - D-Link DFL-900 User Manual

DFL-900/1500 User Manual

1.8.2 WAN1-to-DMZ1 Connectivity

This section tells you how to provide an FTP service with a server installed under your DMZ1 to the public Internet users. After
following the steps, users at the WAN side can connect to the FTP server at the DMZ1 side.
Step 1. Device IP Address
Setup the IP Address and IP Subnet
Mask for the DFL-1500 of the DMZ1
interface.
Step 2. Client IP Range
Enable the DHCP server if you want to use
DFL-1500 to assign IP addresses to the
computers under DMZ1.
Step 3. Apply the Changes
Click Apply to save your settings.
Step 4. Check NAT Status
The default setting of NAT is in Basic
Mode. After applying the Step 3, the NAT is
automatically configured related rules to let
all private-IP LAN/DMZ-to-WAN requests to
be translated with the public IP assigned by
the ISP.
Step 5. Check NAT Rules
The DFL-1500 has added the NAT rules as
the right diagram. The rule Basic-DMZ1
(number 1) means that, when matching the
condition (requests of LAN/DMZ-to-WAN
direction with its source IP falling in the
range of 10.1.1.254 / 255.255.255.0),
the request will be translated into a
public-source-IP requests, and then be
forwarded to the destinations.
BASIC SETUP > DMZ Settings > DMZ1 Status
ADVANCED SETTINGS > NAT > Status
ADVANCED SETTINGS > NAT > NAT Rules
21
Chapter 1
Quick Start