D-Link DFL-900 User Manual page 117

DFL-900/1500 User Manual
BUTTON
Prev. Page
Next Page
Add
Edit
Delete
Step 3. Customize the rule
Check the Active checkbox. Enter a name for
this rule like IKErule. Enter the Local IP
(192.168.40.0/255.255.255.0)
Address
and the
Remote
(192.168.88.0/255.255.255.0). Select the
Outgoing Interface of this VPN/Firewall
Router. Enter the public IP of the opposite-side
VPN gateway (210.2.1.1) in the Peer's IP
Address. Click the ESP Algorithm and select
Encrypt and Authenticate (DES, MD5).
Enter the Pre-Shared Key as 1234567890.
Click the Apply button to store the settings. Note,
In the Action region. It should choose either ESP
Algorithm or AH Algorithm, or system will
show error message. If you hope to set the
detailed item of IKE parameter. Click the
Advanced button in this page. Otherwise it is ok to
just leave the value default.
FIELD
Active
Status
IKE Rule Name
Local Address
Condition
Type
IP Address
If there are more than one action pages, you can press Prev. Page to back to the previous page.
If there are more than one action pages, you can press Next Page to go to the next page.
Insert a new IPSec rule.
Edit the properties of the indicated IPSec rule.
Delete the indicated IPSec rule.
Table 13-3 Add an IPSec policy rule
ADVANCED SETTINGS > VPN Settings > IPSec > IKE > Add
IP Address
Self local IP
Address
The opposite
side IP Address
DESCRIPTION
This field will activate this IPSec policy rule
The name of this IPSec policy
Determine the method to connect to the remote
side of VPN by using the local subnet or the
local single host.
The local IP address
Virtual Private Network – IPSec
DESCRIPTION
109
Chapter 13
Range / Format EXAMPLE
Enable/Disable
text string
Subnet Address /
Subnet Address
Single Address
IPv4 format 192.168.40.0
Enabled
IKErule