D-Link DFL-900 User Manual page 246

A.2
status (st)
version (ver)
Note: If you don't know what parameter is followed by the commands, just type "?" following the command. Ex "ip ?". It will show
all the valid suffix parameters from "ip".
Privileged mode
Main Sub commands
commands
?
disable (dis)
exit (ex)
ip
arp
dns
ifconfig
ping
tftp
upgrade/backup
traceroute
sys
halt
password
reboot
resetconf
saveconf (sa)
status (st)
tcpdump (tc)
version (ver)
D-Link
sys status
sys version
Table A-1 Non-privileged mode of normal mode
Example
?
disable
exit
ip arp status
ip dns query www.yam.com.tw
ip ifconfig INTF1 192.168.1.100
255.255.255.0
ip ping 202.11.22.33
ip tftp upgrade image
<FILENAME> 192.168.1.170.
ip traceroute 202.11.22.33
sys halt now
sys password
sys reboot now
sys resetconf now
sys saveconf
sys status
sys tcpdump INTF0 host 10.1.1.1
sys version
Table A-2 Privileged mode of normal mode
Show system and network status
Show DFL-1500 firmware version
Command description
Show the help menu
Turn off privileged mode command
Exit command shell
Configure IP related settings
Show the ip/MAC mapping table
Show the IP address of the www.yam.com.tw.
Configure the ip address of each port
Send ICMP echo request messages
Upgrade/Backup firmware/configuration from/to tftp
server. About the full description, please refer to Section
A-3.
Trace route to destination address or hostname.
Configure system parameters
Shutdown system
Change administrator password
Reboot system
Reset system configuration to default settings
Save running configuration
Show system and network status
Capture the information of specified packets which pass
through the indicated interface.
Show DFL-1500 firmware version
238