Buell X1 2002 Service Manual page 111

HOME
ASSEMBLY/INSTALLATION
1. See Figure 2-67. If removed, install new bearing cups
into frame steering head using STEERING HEAD
BEARING RACE INSTALLER (Part No. HD-39302).
2. See Figure 2-66. Liberally coat the bearing cones (4)
with grease using WHEEL BEARING PACKER TOOL
(Part No. HD-33067). Work the grease into the rollers.
3. Install lower bearing.
a. Place lower bearing dust shield (3) over fork stem.
b. Find a section of pipe having an inside diameter
slightly larger than the outside diameter of the fork
stem.
c. Press bearing (4) with small end up onto fork stem
and lower triple clamp (6). Use the pipe as a press-
on tool.
4. Insert lower triple clamp (6) through the steering head.
Install the upper bearing (4) with small end down and
dust shield (3) onto fork stem.
5. See Figure 2-68. Apply LOCTITE ANTI-SEIZE to fork
stem bolt (1). Loosely install upper triple clamp (2) using
fork stem bolt.
6. Install fork assemblies. See
7. Install steering head lock. See
LOCK.
8. Install instrument support and handlebars. See
INSTRUMENT SUPPORT.
9. Check adjustment.
a. Tighten fork stem bolt (1). Check bearing adjust-
ment to set fork stem bolt to proper tension. See
1.17 STEERING HEAD
b. Make sure the fork stem turns freely, then tighten
the fork stem clamp screw (3).
2002 Buell X1: Chassis
2.16 FRONT FORK.
2.18 STEERING HEAD
2.26
BEARINGS.
h39302
Figure 2-67. Steering Head Bearing Race Installer
7055
1
1. Fork Stem Bolt
2. Upper Triple Clamp
3. Fork Stem Clamp Screw
Figure 2-68. Fork Stem Clamp Screw
2
3
2-43