Buell X1 2002 Service Manual page 302

HOME
TROUBLE CODE 56
GENERAL
Cam Sync Failure
This code occurs only when the engine is running if the elec-
tronic control module either does not receive a signal from
the cam position sensor or receives an unexpected signal.
The motorcycle may continue to run, not run normally or stop
running altogether.
DIAGNOSTICS
Diagnostic Notes
The reference numbers below correlate with the circled num-
bers on the Code 56 flow charts.
1. Connect BREAKOUT BOX (Part No. HD-42682) to ECM.
See 4.7 BREAKOUT BOX.
2. Use HARNESS CONNECTOR TEST KIT (Part No. HD-
41404), black pin probes and patch cord.
3. See 4.30 CAM POSITION SENSOR AND
4-84
3
1. Timer Plate Stud (2)
ROTOR.
2. Sensor Wiring
3. Cam Position Sensor
2
1
Figure 4-66. Cam Position Sensor
2002 Buell X1: Fuel System
4.28
b0313a7x