Buell X1 2002 Service Manual page 437

HOME
1 1
WARNING WARNING
After installing seat, pull upward on front of seat to be
sure it is locked in position. If seat is loose, it could shift
during vehicle operation and startle the rider, causing
loss of control which could result in death or serious
injury.
4. Install seat. See 2.40 SEAT.
1 1
WARNING WARNING
Check all handlebar switch operations before riding
motorcycle. Visibility is a major concern for motorcy-
clists. Handlebar switches not operating properly could
result in death or serious injury.
5. Check handlebar switch for proper operation. If operation
fails, reread procedure and verify that all steps were per-
formed.
a. Turn ignition key switch to IGN.
b. Check headlamp LOW and HIGH beam settings.
c. Set headlamp to LOW beam. Press passing lamp
switch. Headlamp should flash HIGH beam for as
long as the switch is pressed.
d. Check left and right turn signals.
e. Activate horn by pressing horn switch.
f. Turn ignition key switch to OFF.
2002 Buell X1: Electrical
6855
Figure 7-52. Routing Handlebar Wires, Right
7100
Figure 7-53. Routing Handlebar Wires, Left
7-39