Instrument Support - Buell X1 2002 Service Manual

HOME

INSTRUMENT SUPPORT

REMOVAL
1. Remove four screws and washers to detach windscreen.
2. See Figure 2-100. Remove speedometer (1) and
tachometer (4). See 7.17 SPEEDOMETER
TACHOMETER.
3. Remove face nut (3) from ignition key switch. See
IGNITION/HEADLAMP KEY
4. Remove indicator lights (5) from instrument support (2).
a. Loosen all four catches on indicator light housing.
b. Remove indicator light housing from behind instru-
ment support.
c. Pull indicator light bezel and graphics panel through
front of instrument support.
5. Pull plastic cap from odometer reset button. Remove but-
ton from behind dash.
6. Remove two screws (6) to detach instrument support
from handlebar clamp.
INSTALLATION
1. See Figure 2-100. Attach instrument support to handle-
bar clamp.
a. Apply LOCTITE THREADLOCKER 243 (blue) to
both screws (6).
b. Align instrument support on handlebar clamp. Install
two screws.
c. Tighten screws to 4-5 ft-lbs (5-7 Nm).
2. Install odometer reset button.
3. Install ignition key switch face nut (3). See
HEADLAMP KEY SWITCH.
4. Install indicator lights (5).
a. Place graphics panel inside indicator light bezel.
Install parts through front of dash.
b. See Figure 2-101. Align wire colors on indicator light
housing with correct symbols on graphics panel.
c. Insert indicator light housing into bezel. Secure with
four catches.
5. See Figure 2-100. Install both instruments. See
SPEEDOMETER and 7.18
6. Attach windscreen using four screws and washers.
2002 Buell X1: Chassis
and 7.18
7.3
SWITCH.
7.3 IGNITION/
7.17
TACHOMETER.
6775
2
1
5
7
1. Speedometer
2. Instrument Support
3. Key Switch Face Nut
4. Tachometer
5. Indicator Lights
6. Screws (2)
7. Trip odometer Reset Button
Figure 2-100. Instrument Support
b0715x2x
Speedometer
BK
S/BE
Reset Switch
[39]
O/W
W
O
Y/R
R
-
PK
BK/Y
BK
BK 1 0
Tachometer
Figure 2-101. Instrument Support Wiring
2.26
4
3
6
Speedometer
Sensor
Odometer
[65]
A B C
1 O/W
2 W 1
3 O
4 Y/R
5
R
6 -
7
PK
8
BK/Y
9
BK
S20
BK
S21
S19
2-63