Buell X1 2002 Service Manual page 136

HOME
4. See Figure 2-110. Position rear end of exhaust header in
port as shown. Do not install exhaust header clamp over
port.
5. Rotate exhaust header so that front end of exhaust
header is in position at front port to cylinder head.
6. See Figure 2-109. Fasten exhaust header to cylinder
heads with exhaust header clamps and nuts. Tighten
nuts to 6-8 ft-lbs (8-11 Nm) using SNAP-ON SWIVEL
SOCKET (Part No. PFSX916).
7. Install oxygen sensor to header if removed. Apply LOC-
TITE ANTI-SEIZE LUBRICANT to threads of sensor and
install to exhaust header. Tighten sensor to 42-45 ft-lbs
(57-61 Nm). Attach oxygen sensor connector [137].
Secure wiring and sensor with new cable ties.
8. Tighten muffler clamp hardware to 40-45 ft-lbs (54-61
Nm).
9. Install chin fairing. See 2.34 CHIN
2-68
FAIRING.
2002 Buell X1: Chassis