Table of Contents
Advertisement
6
Setup
To configure IP Conflict errors:
1. Under Event Type, select IP Conflict.
2. Check Enable to enable IP Conflict errors.
3. Check Record to record to the microSD / SD card when IP Conflict errors occur.
NOTE
The camera must support microSD / SD card recording to use this function. Check the technical
specifications for your camera.
4. Under Post Record, enter the number of seconds the camera will record after an IP
Conflict
5. Check Relay-out to trigger an alarm out device when IP Conflict errors occur. Under
Alarm Delay, enter the number of seconds before the alarm out device will be
activated.
NOTE
Relay-out is only available if your camera supports alarm output. Check the technical specifications
for your camera.
6. Check Send Email to send an email alert when IP Conflict errors occur.
7. Click Save to save changes.
6.3.4 Network
Some cameras group the IP Conflict and Disconnection warnings into a single Network
warning tab.
To enable IP Conflict / Disconnection errors:
1. Under Event Type, select Disconnection or IP Conflict.
2. Check Enable to enable the selected warning type.
6.3.5 Illegal Access
Set the camera to trigger an alarm (if supported) or send an email when the username or
password is incorrectly entered multiple times to access the camera.
#LX400062; r. 1.0/24298/24299; en-US
34
Advertisement
Table of Contents
