Table of Contents
Advertisement
6
Setup
To configure Disconnection Errors:
1. Check Enable to enable Disconnection errors.
2. Check Record to record to the microSD / SD card when Disconnection errors occur.
NOTE
The camera must support microSD / SD card recording to use this function. Check the technical
specifications for your camera.
3. Under Post Record, enter the number of seconds the camera will record after a Dis-
connection error.
4. Check Relay-out to trigger an alarm out device when Disconnection errors occur.
Under Alarm Delay, enter the number of seconds before the alarm out device will be
activated.
NOTE
Relay-out is only available if your camera supports alarm output. Check the technical specifications
for your camera.
5. Check Send Email to send an email alert when Disconnection errors occur.
6. Click Save to save changes.
To configure IP Conflict errors:
An IP Conflict error occurs if another device is assigned the same IP address as the IP
camera.
#LX400062; r. 1.0/24298/24299; en-US
33
Advertisement
Table of Contents
