Qos (Service Only); Event; Motion Detect - FLIR T43 Instruction Manual

6 Setup
To enable multicast:
1. Under Main Stream or Sub Stream, click Enable. The main stream and sub stream
cannot be enabled at the same time.
2. Under Multicast Address, enter the desired multicast IP address. For example,
239.255.42.42.
3. Under Port, enter your desired port for main stream, such as 36666 for main stream.
Main and sub stream should have different ports if multicast IP is the same.
Use the following URL to retrieve the video:
• rtsp://<IP Address>/cam/realmonitor?channel=1&subtype=<0 for main stream or 1 for
substream>&unicast=false
For example, if the camera has the IP address 192.168.250.226, and multicast data
as above, use:
• Main Stream:
rtsp://192.168.250.226/cam/realmonitor?channel=1&subtype=0&unicast=false
• Sub Stream:
rtsp://192.168.250.226/cam/realmonitor?channel=1&subtype=1&unicast=false

6.2.11 QoS (Service Only)

6.3 Event

6.3.1 Motion Detect

The Video Detect menu allows you to set up motion detection and recording.
NOTE
Recording functions require an FTP server or an on-board microSD card. Some camera models do not
support these recording features.
To set up motion detection settings:
1. Check Enable to enable motion detection.
#LX400062; r. 1.0/24298/24299; en-US
27