Table of Contents
Advertisement
3
Tri-Mode IP/MPX/Analog
Overview
The cameras offer three video output modes: standard analog, high definition (MPX), and
IP.
• IP / PoE: Provides high definition video output through Ethernet. If you are not using
PoE, make sure to connect the camera to a power source.
• MPX: Provides high definition video output through a BNC connector. To use MPX
mode, insert the MPX terminator into the camera's Ethernet cable before you power on
the camera. When the terminator is installed, IP / PoE mode is not available. If the cam-
era is powered up without the terminator installed, IP and analog mode is enabled.
MPX terminator
• Analog: Provides high definition video output through a BNC connector.
NOTE
After the camera is powered on, it may take up to 2 minutes for the camera to fully boot up and show a
picture.
#LX400062; r. 1.0/24298/24299; en-US
3
Advertisement
Table of Contents
