System Alerts - FLIR T43 Instruction Manual

6 Setup
To configure alarm device settings:
1. Configure the following:
• Under Relay-In, select the alarm device you would like to configure.
• Check Enable to enable the selected alarm input device.
• Click Setup next to Working Period to set a schedule for alarm device activation.
• Under Anti-Dither, enter the latch time in seconds.
• Under Sensor Type, select NO (Normally Open) or NC (Normally Closed) depend-
ing on the type of sensor used.
• Check Record to record when a sensor device is triggered.
• Under Post Record, enter the amount of time the system will record when a sensor
device is triggered.
• Check Relay-out to activate an alarm output device (e.g. strobe light) when the
sensor device is triggered. The camera must have an alarm output to use this fea-
ture. Enter the number of seconds before the camera will trigger the external device
under Alarm Delay.
• Check Send Email for the camera to send out an alert email when the sensor de-
vice is triggered.
• Check Snapshot for the camera to save a snapshot to FTP or microSD when the
sensor device is triggered.
2. Click Save to save changes.

6.3.3 System Alerts

System Alerts include notifications for SD Card, Network, and Illegal Access issues. Each
event can be configured independently.
NOTE
The No SD Card warning is only available on cameras that support SD / microSD cards. Check the tech-
nical specifications for your camera.
#LX400062; r. 1.0/24298/24299; en-US
30