Table of Contents
Advertisement
6
Setup
To configure audio settings:
1. Check Enable under Main Stream, Sub Stream, or both to enable audio.
2. Under Encode Mode, select an encoding mode from PCM, G.711A and G.711Mu.
3. Click Save to save changes.
6.2 Network
6.2.1 TCP-IP
The TCP-IP menu allows you to configure the camera for DHCP or Static IP addressing.
To configure IP address settings:
1. Under Host Name, enter the Host Name for the camera up to 32 characters.
2. Under IP Version, select IPV4 or IPV6.
3. Under Mode, select Static or DHCP. If you select Static, configure the IP Address,
Subnet, Mask, Default Gateway, Preferred DNS Server, and Alternate DNS
Server.
4. Click Save to save changes.
6.2.2 Connection
The Connection menu allows you to configure the camera ports and maximum connec-
tions to the camera. You must port forward the HTTP (default: 80) and TCP (default:
35000) port numbers on your router to enable remote connection to your camera.
NOTE
If you are not using an NVR and are setting up multiple cameras in the same network for remote access,
you must assign unique TCP and HTTP ports for each camera. Two cameras cannot share the same port
number.
#LX400062; r. 1.0/24298/24299; en-US
21
Advertisement
Table of Contents
