Maintenance; Cleaning; Battery Considerations And Service; Disposal Of Electronic Waste - FLIR TG275 User Manual

Automotive diagnostic thermal camera

Hide thumbs Also See for TG275:

Table of Contents

Maintenance

Wipe the housing with a damp cloth as needed. Do not use abrasives or sol-

vents. Clean the lenses with a high-quality lens cleaner.

The rechargeable lithium battery is not user-serviceable. Please contact FLIR

support for service instructions: https://support.flir.com.

For best results, charge the battery immediately after seeing a low battery in-

dication using the supplied USB-C cable (with an AC wall charger, not sup-

plied). The wall charger must be rated for at least 5V/1A. If the battery is

allowed to fully drain, allow 2~3 hours before the charging display appears

after connecting to an AC charger; a full charge (100%) requires 6 hours, a

charge to 90% power requires 4 hours. Charging through a PC USB port is

not recommended.

If the TG275 is not going to be used for an extended period (> 3 months), it

should be charged to at least 70%, stored at room temperature, and re-

charged every 6 months. Failure to do so may result in a battery that cannot

be recharged and that therefore will require service.

As with most electronic products, this equipment must be disposed of in an

environmentally friendly way, and in accordance with existing regulations for

electronic waste. Please contact your FLIR Systems representative for addi-

tional information.

If the TG275 display freezes or if the TG275 in any way stops operating nor-

mally, press and hold the up and down buttons for at least 10 seconds. Re-

lease the buttons when the TG275 switches OFF. After the device switches

OFF, switch it back ON again to resume use. No data will be lost by resetting

the TG275. If problems persist, contact FLIR for support.

#NAS100009; r. AJ/63868/63869; en-US

Table of Contents