Trouble Shooting & Maintenance - Exerpeutic 1115 Owner's Manual

TROUBLE SHOOTING & MAINTENANCE
TROUBLE SHOOTING
PROBLEM: The recumbent bike wobbles when in use.
SOLUTION: Turn the rear stabilizer end cap on the rear stabilizer or adjustable
leveler on the bottom of the rear main frame as needed to level the recumbent bike.
PROBLEM: There is no display on the computer console.
SOLUTION: Remove the computer console and verify the wires that come from the
computer console are properly connected to the wires that come from the front
post.
PROBLEM: There is no heart rate reading or heart rate reading is erratic /
inconsistent.
SOLUTION: Make sure that the wire connections for the hand pulse sensors are
secure.
SOLUTION: To ensure the pulse readout is more precise, always hold on to the
handlebar grip sensors with two hands instead of just with one hand only.
SOLUTION: Avoid gripping the hand pulse sensors too tight. Try to maintain
moderate pressure while holding onto the hand pulse sensors.
PROBLEM: The recumbent bike makes a squeaking noise when in use.
SOLUTION: The bolts may be loose on the recumbent bike. Please inspect all of
the bolts and tighten any loose bolts.
MAINTENANCE
Cleaning
The recumbent bike can be cleaned with a soft clean damp cloth. Do not use
abrasives or solvents on plastic parts. Please wipe your perspiration off the
recumbent bike after each use. Be careful not to get excessive moisture on the
computer display panel as this might cause an electrical hazard or electronics to
fail.
Please keep the recumbent bike, especially the computer console out of direct
sunlight to prevent screen damage.
Please inspect all assembly bolts, nuts, screws, and pedals on the machine for
proper tightness every week.
Storage
Store the recumbent bike in a clean and dry environment away from children.
29