Trouble Shooting & Maintenance - Exerpeutic 1200 Owner's Manual

MAINTENANCE & TROUBLE SHOOTING
MAINTENANCE
Cleaning
The bike can be cleaned with a soft clean damp cloth. Do not use abrasives or
solvents on plastic parts. Please wipe your perspiration off the bike after each
use. Be careful not to get excessive moisture on the computer display panel as
this might cause an electrical hazard or electronics to fail.
Please keep the bike, especially the computer console out of direct sunlight to
prevent screen damage.
Please inspect all assembly bolts, nuts, screws, and pedals on the machine for
proper tightness every week.
Storage
Store the bike in a clean and dry environment away from children.
TROUBLE SHOOTING
PROBLEM: There is no display on the computer console.
SOLUTION: Remove the computer console and verify the wire that comes from the
computer console are properly connected to the wires that come from the rear
frame.
SOLUTION: Check if the batteries are correctly positioned and battery springs are
in proper contact with batteries.
SOLUTION: The batteries in the computer console may be dead. Replace with
new batteries.
PROBLEM: There is no heart rate reading or heart rate reading is erratic /
inconsistent.
SOLUTION: Make sure that the wire connections for the hand pulse sensors are
secure.
SOLUTION: To ensure the pulse readout is more precise, always hold on to the
handlebar grip sensors with two hands instead of just with one hand only.
SOLUTION: Avoid gripping the hand pulse sensors too tight. Try to maintain
moderate pressure while holding onto the hand pulse sensors.
PROBLEM: The bike makes a squeaking noise when in use.
SOLUTION: The bolts may be loose on the elliptical trainer. Please inspect all of
the bolts and tighten any loose bolts.
17