Exerpeutic 1115 Owner's Manual page 15

ASSEMBLY
Tool:
Allen Wrench 6mm
6. Front Post and Front Post Cover and Foot Pedals Installation
Use 6mm Allen Wrench to remove four Washers (40), four Bolts (49), one bolt (39), and one
Big Curve Washer (36) from the tube of the Front Main Frame (73).
Slide the Front Post Cover (54) up to the Front Post (48).
Connect the Extension Sensor Wire (51) and Extension Hand Pulse Sensor Wire II (55)
from the Front Main Frame (73) to the Extension Sensor Wire I (50) and Extension Hand
Pulse Sensor Wire III (44) from the Front Post (48).
Insert the Front Post (48) onto the tube of the Front Main Frame (73) and secure with four
Washers (40), four Bolts (49), one bolt (39), and one Big Curve Washer (36) that were
removed. First lightly tighten four Bolts (49) on the side of the Front Post (48) and one Bolt
(39) on the front of the Front Post (48) by hand. After all five bolts are lightly tightened by
hand, the next step is to tighten the front Bolt (39) with 6mm Allen Wrench until firm. Then
tighten the other four Bolts (49) on the side of the Front Post (48) with 6mm Allen Wrench
until firm.
Slide the Front Post Cover (54) down to the Front Main Frame (73).
14