Checking The Direction Of Servo Operation; Adjusting The Servo Neutral Position - Hirobo S.R.B. Quark User Manual

i
Turn on the lransmitter oower switch.
Resei the data or select a model that does not have data entered. Some
manuiacturers use revolution mixing (ta I clrve) in the initial setting so it is
important to disable this function or set all va ues to 0%.
Turn on the llying unit power switch.
Checking the direction of servo operation
Check to ensure that operat ng lhe transrnitter stjcks moves the servos as
shown in the diagram be ow.
lf the allocation or movement direction oi lhe servo differs from the
diagram, reset the setting as shown in the table of "Channel setting ior
each transmitter manuJactured'in lhe previous page, according to the
transmitter's instruciion manual.
(Pointl
Please do
position of
hole.
not change the
the servo horn
lild.nl
5. Adjusting the servo neutral posilion
When the aileron and elevator strcks of the transmitter are in the neulral
posiiion, ad usl the transmitter irims so that the aileron and elevator servos
are in the oositions as shown below.
In lhe case thai a computer transmitler is used, use the sub tdm iunclion.
_ . - - - - l
tl,rode I I
t + k d ; : q f
29